

Wood, Gas and Pellet
Many homes started with a wood-burning fireplace and later gained gas logs in the same brick firebox. The look is classic, but the setup brings its own questions: where the damper should sit, whether the old flue is sound and how soot from earlier fires affects the new burner. Chimney Sweep White Rock handles Gas Fireplace Cleaning on these converted hearths and pairs it with a Chimney Sweep when the flue calls for one. We find these conversions all over White Rock, and they deserve a clear explanation.
Even if only gas has burned for a while, earlier wood fires may have left soot, and cracked tile or loose mortar can sit unseen. We sweep and look.
Logs and ember media go back in the layout the manufacturer designed, and the damper is checked for the right opening, so the flame burns cleanly.
A chimney full of cold air behaves like a plug. When a fire is lit beneath it, heavy air sinks and pushes smoke back into the room before the flue has warmed enough to pull it upward. Tall and outside-wall chimneys are especially prone.
Chimney Sweep White Rock sees this often and has a few gentle fixes. Opening the damper early, warming the flue with a rolled sheet of newspaper and starting a small, hot fire usually get the draft going before the room fills.
If the problem is constant, we look for a cause behind it, such as a blocked cap, a narrowed flue or a house that is too tight. In White Rock, getting the first five minutes of a fire right makes the rest of the evening much nicer.


This movable plate sits above the firebox and controls airflow. We show you how to open it fully before a fire and close it afterward.
A ledge behind the damper catches falling debris and rain, and it tends to collect more than anyone expects.
Clay tile or metal lines the inside of the chimney and protects the structure around it from heat and exhaust.
The slab across the top of the stack carries rain away from the flue and the brick below it.
A cover with mesh sides keeps rain, leaves and animals out while still letting smoke escape.
Thin metal sealing the chimney to the roof blocks leaks, and it is the first place a gap or lifted edge shows up.